Info Mjj
Initial setting for Set print mode 1 0x00 Premium Glossy Photo Paper, 0x10 Photo Quality Ink Jet Paper, 0x20 Plain Paper, 0x30 Photo Lower 4bits Default of Paper Size 0x00 89mm Roll, 0x01 127mm Roll, 0x02 4 Roll, 0x03 210mmRoll, 0x04 4x6, 0x05 Letter, 0x06 5x7, 0x07 8x10
Overview
This section describes the operating principles of the printer mechanism and electrical circuit boards. The Stylus PHOTO 895 785EPX has the following boards Power supply board C408 PSB PSE Monochrome panel board C408 PNL Printer panel board C408 PNL-B The printer mechanism for Stylus PHOTO 895 785EPX is designed newly. But, the basic component of the printer mechanism is same as previous product. This printer consists of Print Head, Carriage Mechanism, Paper Feeding Mechanism, Paper Loading...
Ink system unit removal Cap Pump unit
1. Remove the Housing from the printer. Refer to Section 4.2.1 Housing Removal 2. Remove the Waste drain ink pad from the printer. Refer to Section 4.2.6 Waste drain ink pad unit removal 3. Remove one screw C.B.S P4 3x6 F ZN and detach the pump unit cover. Figure 4-40. Pump unit cover removal Figure 4-40. Pump unit cover removal 4. Remove four screws C.B.S 3x6 F ZN securing the Ink system frame and the Cap assembly to the frame. 4. Remove four screws C.B.S 3x6 F ZN securing the Ink system frame...
Disassembly
The flowchart below shows step-by-step disassembly procedures. When disassembling each unit, refer to the page number shown in the figure.
EEPROM initial setting
It is required to write the initial setting values into EEPROM when the Main board is replaced. Click on the OK button to write the initial setting values into EEPROM. This adjustment writes the ID numbers for the Printhead into the EEPROM, and enables the current settings to be confirmed. Figure 5-8. Head ID adjustment items Figure 5-8. Head ID adjustment items Check the 13-character ID written on each of the print heads, and enter the ID for the head that has been replaced. Click on the OK...
Waste drain ink pad unit removal
1. Remove the Housing from the printer. Refer to Section 4.2.1 Housing Removal 2. Remove two screws C.B.S. 3x6, F ZN and C.B.P. 3x8, F ZN and detach the Sub Left Panel Housing from the printer mechanism. Detach the stacker at the same time Figure 4-19. Removing the waste drain inkpad unit Figure 4-19. Removing the waste drain inkpad unit 3. Lift the left side of printer and disengage the hook of waste drain ink pad unit, then pull out the waste drain ink pad unit to remove. I Connect the CR...