I Clq
When removing HOUSING, PANEL, LEFT, watch out for the Stacker Assembly. Since the Stacker Assembly is fixed by the Panel Unit and HOUSING, PANEL, LEFT, it will come off as HOUSING, PANEL, LEFT is removed. 6. Remove 2 screws CBS, 3x6 securing HOUSING, SUB, LEFT to the printer mechanism. 7. Release 3 hooks 2 at the bottom and 1 in the front fixing HOUSING, SUB, LEFT to the printer mechanism, and remove HOUSING, SUB, LEFT. 8. Remove 1 or 2 screws CBP, 3x6 Stylus Photo 890 1 screw, Stylus Photo...
Info Bqo
Figure 4-39. LEVER, HOPPER, RELEASE Installation Figure 4-40. LD Roller Assembly Installation 1 Figure 4-40. LD Roller Assembly Installation 1 When installing the edge guide to the left LD Roller Assembly, ensure that the rib in the LD Roller Assembly fits correctly into the groove in the edge guide. See Figure 4-41. Make sure that the right LD Roller Assembly is fixed with the hook in FRAME, ASF B. You can check its condition from the back of the ASF Unit. See Figure 4-42. Before assembling...
Sequential Repair Adjustment Program
This program is common for both Stylus Photo 890 and Stylus Photo 1290. NOTE In this section, Stylus Photo 890 program windows are used as examples. In this section, the sequential operations needs to be done are explained. This service program provides appropriate adjustment orders for repair, and the following adjustment items are included Carriage Unit Replacement Removal Printer Mechanism Replacement 1. Start the program and input all the required information on the initial window. Make...
Overview 1
This chapter describes procedures for disassembling the main components of the EPSON Stylus Photo 890 1280 1290. Unless otherwise specified, disassembly units or components can be reassembled by reversing the disassembly procedure. Therefore, no assembly procedures are included in this chapter. Precautions for any disassembly or assembly procedure are described under the heading CAUTION and CHECK POINT. Any adjustments required after disassembling the units are described under the heading...
Info Dmi
Figure 5-32. Present Adjustment Data Display Figure 5-32. Present Adjustment Data Display 5. To exit or continue the program, click Quit on the lower left. Refer to Figure 5-17.Exit Window on page -131. You are required to perform Input USB ID whenever you replace the main board. The Stylus PHOTO 1280 is equipped with the USB interface as standard. In the Windows 98 or iMAC environment, the USB port driver controls its device using the USB ID stored in EEPROM. Therefore, you need to input a...
Asf Sensor
Figure 2-27. ASF Pump Motor Circuit Block Diagram C393MAIN C393MAIN-C Figure 2-28. ASF Pump Motor Circuit Block Diagram C393MAIN-B Stylus Photo 890 1290 has the following five sensors to detect printer's status. Ink cartridge sensor CSIC connector on the head board The block diagram for the sensor circuit is as shown below The block diagram for the sensor circuit is as shown below Figure 2-29. Sensor Circuit Block Diagram C393MAIN C393MAIN-C Figure 2-29. Sensor Circuit Block Diagram C393MAIN...