Adjustment Required
Shield Plate M/B Assembly
Be sure to perform the following adjustments after replacing the Main Board;
1. Head voltage ID Input (Refer to Chapter 5.)
2. Bi-D adjustment, including Head Gap Adjustment (Refer to Chapter 5.)
3. USB ID data input (Refer to Chapter 5.)
Be sure to exchange the following parts also when replacing the Main Board;
1. Waste Ink Absorption Pad
This parts exchange is required since the several ink counters stored in the EEPROM are lost when the Main Board is replaced.
Make sure each cable is set in the correct cable holder (A or B) on the M/B Shield Plate. Refer to Figure 4-5.
- Figure 4-4. Removing Each Circuit Board
Since the CN10 is a locking connector, be sure to release the locks before removing the cables.
Also, make sure to lock them when connecting the cable.
Äi RR Encoder Sensor FF* *CRJ Motors-ASF HP Sensor Cable! f . __ u mm ■
Figure 4-5. Setting the Cables to Holders A and B
nrintnnm/ info
Average user rating: 5 stars out of 1 votes
Post a comment