V V
The GND can be output by placing the probe of the oscillo scope to the tapped hole in the bottom plate on the board with a screw. Trying the initial ink charge operation. Unlike the previous products, the Stylus Color 860 1160 is not equipped with the CL3 dummy cleaning . Therefore, you can repeat the cleaning every time you press the Cleaning button without running a self-test nor any printing. You can repeat the initial ink charge operation in the way described below 1. Using the exclusive...
Removing the Waste Ink Absorber Tray Assembly
1. Remove the Upper Housing. Refer to Section 4.2.1. 2 Remove one screw No.1 securing the Left Housing Panel to the Printer Mechanism. Refer to Figure 4-9. 3 Remove two screws No.1 securing Left Sub Frame and remove Left Sub Frame. Refer to Figure 4-9. Figure 4-9. Removing the Left Housing Panel amp Left Sub Frame Figure 4-9. Removing the Left Housing Panel amp Left Sub Frame 4 Insert a screw driver through the center hole on the Paper Eject Assembly and remove one screw No.3 securing the Lower...
How to set up the program
In order to set up the program, insert 1st FDD 3.5 inch disk Installer Disk to the 3.5 inch FDD disk drive and start the install the program file in the Windows environment. After complete the set up, the SC760 860, 1160 Adjustment Program icon is added to the Program menu in the Start menu. NOTE Correct program is automatically installed according to your OS Windows95 or Windows 98. The following figure shows you the U I of the Adjustment main menu. ggstylus COLOR 760 860 1160 Service Program...
Initial Ink Charge Operation
After replacing any of the following units, perform Initial ink charge and return the printer after making sure that ink is ejected correctly from the printhead. After replacing the printer mechanism After replacing or removing the printhead Before you perform the initial ink charge operation, replace the installed ink cartridges with new ones, because the ink amount used for the initial ink charge operation is so large. 1. Select the Maintenance menu. The following menu appears. Stylus COLOR...
O Dke
Figure 5-21. Head fixing screw position NOTE Loosen the printhead securing screw securing the printhead on the carriage. You don't need to remove it completely. Select the Move the carriage to the head angular adjustment 6. Look at the black magenta combination in the pattern and move the adjusting lever to make the magenta lines stay between the black lines with even space. The figure below shows how the pattern changes as the adjusting lever moves right rear or left front . 7. After changing...