Figure Fuser Control Circuit
The following figure shows the fuser temperature control procedure. The following figure shows the fuser temperature control procedure. Figure 2-20. Temperature forFuser Control Procedure Figure 2-20. Temperature forFuser Control Procedure If the following renditions are detected, the printer indicates a fuser error the LCD displays SERVICE REQ. E0003 . . The thermistor temperature does not reach 55 C 131 F within 15 seconds. . The warm-up period doesnotend within 120 seconds. The thermistor...
EEPROM Format
EEPROM format operations are required only when the Video Controller Board C125 MAIN board or EEPROM is replaced and these operations are specified in the accompanying documentation. EEPROM format functions printer mme, default paper size A4 or letter , toner counter, page counter, jam counter, and panel settings are all stored in memory. Defaults for the EEPROM format functions can be written to EEPROM as follows Turn on the printer while holding down the ITEM, t, and CONTINUE buttons until...
Figure Exterior View of the EPL and olun
Table 1-1 lists the optional units available for the EPL-5600 and ActionLaser 1600. Table 1-1. Options for EPL-5600 and ActionLaser 1600 Table 1-1. Options for EPL-5600 and ActionLaser 1600 Level 2 mode PostScript Level 2 compatible fonts and commands 250 sheet lower paper cassette for EPL-5600 A4 250 sheet lower paper cassette for AL-1 600 Letter Ethernet interface card for NetWare Note LocalTalk card C82312 cannot use with LocalTalk I F module C82326 . Note LocalTalk card C82312 cannot use...
Paper Feeding
There are two methods of feeding the paper into the printer. One is by using the multi-purpose tray standard tray , and the other is by using the optional 250-sheet lower paper cassette. Paper-out conditions are detected by the paper empty sensor, located above the paper tray or the cassette. While paper is in the tray or cassette, the detection lever for the paper empty sensor is lifted. When the paper supply runs out, the detection lever is lowered, causing the shutter to interrupt light from...
Fig Gear and Roiler Positions
Fig. 2-15. Feeding Drive Fig. 2-16. Feeding Drive Section Section Option Fig. 2-15. Feeding Drive Fig. 2-16. Feeding Drive Section Section Option Figure 2-17 shows the main motor drive circuit. The main motor Ml is a four-phase stepping motor. This motor is controlled by the CPU IC1 A on the engine controller board PWB-A . The power supply board PWB-E has a stepping motor driver IC. This IC drives the main motor Ml with a constant current. The main motor Ml is stopped when the CPU ICl A on the...